Top wood trim for slide pushed out

2 Lucky

393
OwnPC: Yes
NewUsed: Used
PurchDate: 02/27/18
Model: 2551
ModelYear: 2010
Slide: Yes
IntColor: Cherry
ExtColor: Classic Umber
Location: Grand Junction, Colorado

Re: Top wood trim for slide pushed out

« Reply #15 on: October 30, 2021, 05:53:23 pm »

Quote from: JJCruiser on October 30, 2021, 02:12:22 pm

I have the 500:1 motors in my 2351. It is also my understanding that the wood trim is key when stopping the slide when it is fully extended. So far my trim frame is fine, but I would not mind if it had a few more screws holding it in place. The spacing on the center most set of screws is a bit over 12 inches with the two outer most having a spacing of about 19 inches.

JJ

If the trim really is the stop for the slide, disregard my method to fix the top board by nailing the corner together. It really should be removed and beveled on the back side top edge so it does not hit the wall first.

Logged

Riding the fine line between bravery and stupidity since infancy.

Engineerlt

Re: Top wood trim for slide pushed out

« Reply #16 on: October 30, 2021, 05:58:30 pm »

JJCRUISER how big is the slide on your PC? Is it similar size to the 2552? Interesting that PC used 500:1 motors. Appreciate the information.
Very Respectfully
Lance

Logged

JJCruiser

130
OwnPC: Yes
NewUsed: New
PurchDate: 10/2018
Model: 2351
ModelYear: 2019
Slide: Yes
IntColor: Nightscape
ExtColor: Nightscape
Location: Central Illinois

Re: Top wood trim for slide pushed out

« Reply #17 on: October 30, 2021, 06:40:03 pm »

Quote from: Engineerlt on October 30, 2021, 05:58:30 pm

JJCRUISER how big is the slide on your PC? Is it similar size to the 2552? Interesting that PC used 500:1 motors. Appreciate the information.
Very Respectfully
Lance

I am not real familiar with the 2552, but based on the floor plan diagrams for the 2552 and 2351 on the Phoenix Product tab, it appears the slides are the same.

JJ

Logged

JJCruiser

130
OwnPC: Yes
NewUsed: New
PurchDate: 10/2018
Model: 2351
ModelYear: 2019
Slide: Yes
IntColor: Nightscape
ExtColor: Nightscape
Location: Central Illinois

Re: Top wood trim for slide pushed out

« Reply #18 on: October 30, 2021, 06:59:39 pm »

Quote from: JJCruiser on October 30, 2021, 06:40:03 pm

Quote from: Engineerlt on October 30, 2021, 05:58:30 pm
JJCRUISER how big is the slide on your PC? Is it similar size to the 2552? Interesting that PC used 500:1 motors. Appreciate the information.
Very Respectfully
Lance

I am not real familiar with the 2552, but based on the floor plan diagrams for the 2552 and 2351 on the Phoenix Product tab, it appears the slides are the same.

JJ

Attached is a photo of one of my slide motors.

Logged