2350 Entry Door Hinge Pins

The entry door on my 2350 has started to sag a little and drags on the bottom of the doorframe when I open and close it. I can wiggle the door vertically by grasping it at the bottom, there is just a wee tiny little bit of slop in the door hinge pins.

If you have replaced your hinge pins, what did you use?

Mine does the same.  I lifting the door and inserted a “C” clip under the hinge pin.   It helped for a while but it finally slipped out.  It is a quick and easy if you can get it to stay in.

Mine does the same.  I lifting the door and inserted a “C” clip under the hinge pin.   It helped for a while but it finally slipped out.  It is a quick and easy if you can get it to stay in.

Good suggestion.  Thank you.

https://www.mcmaster.com/standard-washers/washers-4/washers-5/

I don't think the pins are long enough to give enough room for a washer.