Hello Guest!

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Tarnold

Pages: 1 2 [3] 4 5 ... 14
31
General Discussion / Dock/backup lights
« on: September 02, 2021, 08:58:56 am »
Guessing most wiring size is same across the board for like uses on PC models. So I want to add 2 15watt led backup lights, tapped in the current backup light circuit.  Is there enough umph currently there to support the extra draw?

32
General Discussion / Re: PCTC Reunion 2021
« on: September 01, 2021, 12:02:07 pm »
I’ve msg holly, and think I joined the travel club(filled out questionnaire).  Can’t figure out how to password/userid to access further?

33
General Discussion / Re: 50 amp 90* plug REPLACEMENT
« on: August 28, 2021, 02:57:25 pm »
Found lots of those. Really only want to cut off my old “straight” female plug and ADD a 90* in its place

34
General Discussion / 50 amp 90* plug REPLACEMENT
« on: August 28, 2021, 10:10:25 am »
Looking to swap my current plug for a 90 degree, to lessen weight drag when plugged in.  Found lots of 90 * adapters 50 to 50, with short cords.  Really just want to replace, not extend the cord.  Would need the locking ring.  Searched other forums, and the net, but nothing I can find.

35
General Discussion / Re: Diamond shield
« on: August 24, 2021, 04:42:51 pm »
So, 95 views and I’m the only one with the problem?

36
General Discussion / Diamond shield
« on: August 22, 2021, 10:49:57 am »
anyone else having problems with this stuff. Ie:mold/dark spots between film and coach.  Numerous threads on other forums on how to remove, but not currently in the mood to fight with it. 2013/14 2552.  Mirrors, across the top cap on hood.  Just looks bad.

37
General Discussion / Re: Side door hinge
« on: July 26, 2021, 08:53:04 am »
My door has also developed a little sag.  The paint has started to rub on the bottom jam, opposite of the hinge.  Tried to lift and insert split washer under hinge.  Worked for a few openings, but sone downward pressure kicked the split washer out. 

38
General Discussion / Re: Any issue running Houghton AC while driving?
« on: July 20, 2021, 10:01:22 am »
Is the roof thickness on a PC adequate for this unit?

39
General Discussion / Re: 50amp vs 30am hookup question
« on: July 02, 2021, 08:32:06 am »
I find the 50amp plug to generally be in better shape, less use than the 30. 

40
General Discussion / Re: Sealing around bin door frame?
« on: June 27, 2021, 09:49:33 am »
Excellent display of your problem.  Need a detailed tutorial on how you added the arrows and text to describe your problem.  As for the leak, looks like the smallest bead of caulk would fix it.  Run a piece of painters tape to the upper and lower side of the groove to minimize squeeze out.

41
Tips and Tricks / Re: Adding A Propane Tank Shield On Our 2007 2350
« on: May 22, 2021, 08:27:02 am »
Did something similar.  If you have a tractor supply company nearby, they sell horse stall mat by the foot.  Works like your truck mud flap.

42
General Discussion / Re: Dash mat
« on: May 19, 2021, 10:21:34 pm »
Op.  On my previous chinook, it had a dash mat that was the one side of Velcro.  Very convenient  to temporally “fix” stuff, like sunglasses case, tpm monitor, etc.   Also ran wires under it to be hidden but easily assessable. Good sun protection for the dash.   It was a 98 e350.

43
General Discussion / Dash mat
« on: May 18, 2021, 07:38:07 am »
Floor mats have been covered, so along the same lines.  I’m looking for subject.  Searching comes up with “F” series but not “E”. Called one company found on line, but they didn’t make for E series.  So, anyone have a good, well fitting, formed, dash mat.

44
General Discussion / Re: Engine additive
« on: May 17, 2021, 03:20:49 pm »
After adding sea foam, went about 20 miles, check engine light,    Plugged o2 sensor.  Works too good!

45
General Discussion / Re: Drivers side electric swivel seat
« on: May 12, 2021, 02:12:20 pm »
Bigger now but still a little fuzzy.  How much did it raise at the lowest setting?

Pages: 1 2 [3] 4 5 ... 14