Hello Guest!

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DKCruzser

Pages: 1 ... 3 4 [5]
61
General Discussion / Re: Phoenix USA Wheel Simulator's (hub caps)
« on: March 03, 2020, 09:12:53 pm »
I lost a simulator while traveling down a rough road in Az.  I switched from the clip on simulators to the bolt type of simulator.  Easy to install over the lug bolts.  I haven't had any concerns or issues of loosing another simulator.
  http://www.phoenixusa.com
This is not the same as our Phoenix Cruiser companies website.

62
General Discussion / Re: Does a phoenix cruiser have a RVIA sticker
« on: February 03, 2020, 04:34:08 pm »
After the prior discussion of the RVIA sticker I looked on the underside of the hood, around the engine compartment and on the cab doors to include the RV door and could not find my RVIA sticker.   Perhaps someone who has one could post a photo of what their's looks like.

thanks

dave

63
General Discussion / Surge Protector Humming??
« on: January 30, 2020, 01:23:22 pm »
We noticed, after we returned home from our last RV trip and plugged into our home shore power (we have a 50 amp plug), a humming sound coming from behind the panel that houses the Surge Protector indicator, inverter, generator, and tank indicator.   The inverter is off so I don't believe the humming sound is from that.  If I unplug from the power the humming sound goes away.   I suspect it is the Progressive Power Surge making the sound.  There are no error codes on the Progressive indicator panel and everything seems to be functioning.  While not a loud humming sound it is annoying.   How does one access the back of the wall to determine where the humming sound is coming from?  Any thoughts would be helpful. 

2017-2910D

thanks

64
General Discussion / Re: 2019 E 450 dome lights
« on: January 14, 2020, 10:34:59 am »
This is why I appreciate the forum..... I have been trying to understand how to use the dome lights for the past couple of years.  Now I know....... how to control the dome light using the dimmer switch when the courtesy lights go off....

thanks again,,,

dave and karen
2017 -2910D

65
General Discussion / Re: 2019 E 450 dome lights
« on: January 08, 2020, 09:15:24 pm »
Frank - Beth,

Our 2017 - 2910 D does not have the switch located between the 2 DC outlets.  As explained to me this switch provides the ability to use the radio when the ignition is not turned on.  And that this switch was not used in 2017.   Who might know is Doug or Dave at PC......

dave - karen

66
General Discussion / Re: 2019 E 450 dome lights
« on: January 08, 2020, 01:45:51 pm »
Could you please send a photo of that switch between the DC on the dash.   

Our dome light comes on transiently when the door is open.  (you don't need a key in the ignition)  The light will then go off in a minute or so once the door is closed.  This occurs if the toggle switch between the dome lights are pushed to the left.  If the toggle switch is on the right the light will not come on if the door is open.    It would be nice if we were able to turn the light independent of the door being open.  This would be nice if one were stopped and needed to look for something in the cab without having to opening the door. 

67
General Discussion / Re: Lippert Schwintek Lubrication
« on: December 29, 2019, 11:41:38 am »
Thanks for bring this maintenance issue up.   One of the youtube video from Lippert (https://www.youtube.com/watch?v=8KbVRFMo1Rg) it appears the CRC that they recommends comes with a red straw.  Did yours come with that straw since it sounds like your made that straw?   We have the 2910D but I am assuming all the other PC models are using the same Lippert slides?  Hope others will respond on what they do to keep their slides lubricated.     

68
General Discussion / Re: What air compressor do you carry?
« on: October 23, 2019, 11:55:55 pm »
We also use the Viair.   We agree on Mike's points;  the downside being the cost.  But this is a very reliable compressor as we just found out when heading out for the Charleston rally.   It was nice to have when we discovered that one of our tires on the tow car needed air.  Because this compressor can provide high pressures it works well not only with the low pressure for the tow car but higher pressures that are needed for the tires on the RV.   

Dave
2017-2910 D

69
General Discussion / Re: Pioneer Radio with GPS
« on: August 12, 2019, 08:01:36 pm »
We have always wanted to play the Pioneer radio when parked but we are unable to find a "switch".  The radio/navigation system only comes on when the motor is running.  Is it possible we may not have the "button switch" ?   thanks

dave and karen
2017 2910D

70
When I have received a similar error I have found that I had not secured the end of the electrical cable into the rig correctly.  I have a 50 amp on my 2910D and have noticed that I must turn the female end and then tighten securely with the ring nut.  Once I do that the error goes away... and I get the E 0 code meaning no errors

71
General Discussion / Re: Options qustions...
« on: May 15, 2019, 11:16:12 am »
We also have them for our 2910D.  Easy to use but one must be carefully that the magnet doesn't scratch the metal.  Highly recommend them.  When we had to replace our windshield (cracked) it was easy to remove the magnets.  The company sent us new sticky backings to replace our original magnets.

Pages: 1 ... 3 4 [5]