Hello Guest!

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Patrick

Pages: [1]
1
General Discussion / Re: Introduce Yourself!
« on: May 05, 2021, 11:55:37 am »
Hello All
I have been poking around this forum for awhile mostly reading up on the PC's equipment and possible modifications but thought I might just introduce my self
Elaine and I used to sail around and live on a 35' sailboat.  We moved ashore and purchased a VW bus as our first camper.  Then on to VW Rialta by Winnebago.  They were both great but as we age we wanted a little more comfort. I first saw a phoenix crusier in my RV park and was please to see a midsized RV with twin beds like the Rialta we had.  We purchased a 2007 model 2551 in December 2020.  I am impressed with it to say the least.  So far I have got all the lights working, steps in working order and just finished replacing the guts on the Norcold refer to 12 volt compressor style.  The new unit came from JC refrigeration (Dutch Aire) was fairly simple to convert. Looking forward to actually using it soon.  Thanks to all who publish thier upgrades on this site as I am still looking to make improvments  This site is wonderful. 

2
General Discussion / Re: Backup camera monitor location
« on: April 30, 2021, 09:00:22 pm »
Thanks Ron I did this mod and we love it.  I found a simular mounting arm made by RVS (rear view safety) and sold by E-trailer.  shipped out at about $30.00 I am loving this forum finding all kinds of good ideas for my NTM PC (used but New To Me)
Pat

3
General Discussion / Re: Automatic Entry Step
« on: April 27, 2021, 04:19:17 pm »
Joseph
  I checked the step swith with OHM meter and it is good.
I checked the function by using alternate 12 volt supply to white wire at the swith and the unit works as it should.  So problem is the 12 volt supply to the step switch.  I just don't know where the fault is located  I will try again in the morning with fresh eyes to look for blown fuse.  Thanks for the info on the 20 amp fuse but per manual I should find a 5 amp fuse for this circuit

4
General Discussion / Re: Automatic Entry Step
« on: April 27, 2021, 07:56:41 am »
My first post to this forum  I haven't had my PC long but I do have a problem like BANGOBOB in that the steps won't stay out when the step switch is thown.
 Mine is a Kwikee with a date code of 6J17.  According to the manual and wiring diagram shown on Figure 10 there needs to be 12 volt enegized to the white wire of the control unit in order for this option to work.  I suspect a blown fuse some where.  Does anyone know if the is an inline fuze hidden or would this circuit be terminated on fuse panel.  So far I haven't found the fuse. My failing eye sight doesn't help.  Does any one out there know which fuze location I should check.  Any help would be greatly appreciated.

Pages: [1]