Hello Guest!

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jim farley

Pages: [1]
General Discussion / Power Step
« on: July 01, 2022, 02:25:54 pm »
we bought a 2013 3100 PC, it had 2 prior owner's that didn't believe in maintance, sooo, i'm fixing a FEW things, most of the front end steering parts, 6 tires, 4 shocks, at 39,000 it needed all of it, realign front end.  now getting down to less to do, batteries had no water so after water and a good charge they seemed ok, 3 days of not plugged in and new story, batteries are bad, replaced them but now the step hasn't worked since they went dead, don't see a reset, can't find a bad fuse, any idea's?

General Discussion / Re: waterpump switch light
« on: July 01, 2022, 02:08:34 pm »
i found it Lance, thanks for the help, that Mpx Low Side Controller was melted, 58.00dlls to replace the part with 2 screws myself, light is off, guessing prior owner left waterpump on all the time and it got hot

General Discussion / Re: Ceiling light question
« on: June 23, 2022, 03:38:08 pm »
my 2013, 3100 has the same switch for that light, mine had a loose wire at the switch

General Discussion / Re: @%diamond shield
« on: June 23, 2022, 03:34:02 pm »
i used contractors solvent, spray on, wait, used plastic chisel to remove glue

we purchased a 2013, 3100 used in Texas about a month ago and drove it home to Yuma, Arz.  after doing some needed maintance, like rebuilding the front end, 6 new tires, new masserator system , repair ladder, new shocks, and begin removing the Diamond Shield on the front of the coach. really hot and gas is really high sooooo, it sets under our cover for now.  we sold our 43ft Grand Tour tag axle so this is quite a difference to say the least, but my wife is very comfortable driving it unlike the bus. i think we made a good decision. Well i started on removing the DSshield and found that a plastic chisel and contractors solvent will do the job, altho slow process, the paint is saved, hood and front fenders done, but the cap on the top is also cracked, mold 00and bugs are stuck in the shield, it will be a pain but i will get it done, quoted 2700.dlls for a shop to do it

General Discussion / waterpump switch light
« on: June 23, 2022, 02:44:53 pm »
we have a 2013 3100 cruiser and 3 water pump off/on switch's, at each one i red light stays on all the time, no matter what i do to the rocker switch, any fix idea's??

Pages: [1]