Hello Guest!

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Woodchuck

Pages: [1] 2 3 ... 5
1
General Discussion / Re: Generator Access 101 on a 2019 PC 3100
« on: November 03, 2022, 06:46:22 pm »
Hank, The gen door on my 2552 just drops straight down, doesn't come out the opening. I always put a folded towel on the ground in case my senior fingers drop it. To replace the door just reverse the order. My 4000 watt Onan has no filter. That's a first for me! Makes changing oil easy. Hope this helps, Chuck :)

2
General Discussion / Re: Lithium Battery Install
« on: September 14, 2022, 12:42:55 pm »
Well said!

3
General Discussion / Re: Lithium Battery Install
« on: September 13, 2022, 07:53:18 pm »
PARKGT, Just wanted to let you know about a 2014 CRV  EXL loaded listed on Tiffin Classifieds. The car is ready to tow with low miles. This website is open to the public, google Tiffin Classifieds. Glad to see that Lance helped you through some tough stuff. This fourm will miss his knowledge & respectful manner. A friend & Great Guy! I tried to PM you but you were off line.  :) Chuck  P&S: just looked & there's two for sale now.

4
General Discussion / Re: Leveler leaking
« on: September 08, 2022, 07:49:25 pm »
I'm thinking you should check the hydraulic fluid. The tank is under your PC on the generator side (if in the same location as our 2020 2552) The level should be checked when there's no pressure on the hydraulics. When there's no pressure on the lines most of the fluid runs back into the tank. Jacks up, no pressure & most of the fluids in the tank. Hope this helps, Chuck :) 

5
General Discussion / Re: 2910D
« on: August 03, 2022, 09:13:28 pm »
There's a 2015 2910D on RV Trader, located in Florida. :)

6
General Discussion / Re: slideout mechanism is blinking
« on: July 11, 2022, 08:18:24 pm »
My Lippert Schwintek slide controller does the same thing. When we first purchased our unit I called the factory, talked with a tech & was informed that that's the way its wired? The light only blinks when the slide is in. Our controller is in a cabinet & doesn't bother us. We also had Lippert Schwintek slide controllers in our Tiffin Class A, they didn't blink unless sending a code. Sounds like the slide is working properly. If you count the blinks, red & green, it is sending a error code #9 "Hall PWR SHORT TO GND". Again, the factory tech advised that there's nothing wrong with the controller. I'm interested in feed back from others that have Lippert Schwintek controllers. Chuck

7
General Discussion / Re: Access Under Power Twin
« on: July 05, 2022, 10:16:13 pm »
Its been over a year since I removed the surface panels. The panels were all screwed down. The one thing that I remember is some of the screw heads were sunk into the wood & hard to find. Of course, your 2021 might be different from the 2020. Hope this helps, Chuck

8
General Discussion / Re: Tenn rally
« on: May 15, 2022, 03:20:31 pm »
Agree that Lance is the super hero. He pointed out features that we didn't know about. He also found a remote control system for our awning. Gald to meet everyone & learn so much. Love our PC  2o2

9
General Discussion / Re: Request for comments on newer design LED house lights
« on: March 23, 2022, 09:41:57 pm »
No problems with the LED lights. The long lights under the cabinets are touch lights. Touch the end for on & off. There are 5 (adjustable for angle) reading lights, 1 for each bed, 2 over the couch on each end with the touch light in the center & 1 over the single chair. There is no soft setting. The touch lights are bright. Hope this information is what you are looking for.  :)Chuck

10
General Discussion / Re: Ordering Parts
« on: March 18, 2022, 08:50:50 pm »
If you can't catch Dave try Tina at tina@phoenixusarv.com

11
General Discussion / Re: HWH Levelers
« on: March 18, 2022, 08:21:11 pm »
Agree with Lance, mine do the same.  :)

12
General Discussion / Re: Ordering Parts
« on: March 18, 2022, 08:17:19 pm »
Try Dave Ponsler at 1 574 350 2684. It has been about 8 months since I used this # to get Dave. I also ordered the under counter touch lights. Easy to replace. I just tried the PC phone #, the recording has changed but there is a directory that will get you to Dave. Hope this helps, Chuck :)

13
General Discussion / Re: Thetford Sanicon 700 Motor Replacement
« on: March 14, 2022, 05:27:07 pm »
Lance, great job. Thanks for showing the multi meter readings. Hope I never have the problem.  :)Chuck

14
General Discussion / Clear coat on Dometic AC peeling
« on: March 04, 2022, 02:16:44 pm »
The outside clear coat is peeling on my living room roof Dometic AC with heat pump. On our recent trip the heat pump was used several times. All seemed to work as it should. I cleaned the roof in November before putting her to bed. I didn't notice any peeling at that time. We have not parked under any trees & I'm not aware of anything falling or damage of any kind. Anyone else have this problem? Chuck

15
General Discussion / Re: Phoenix Cruiser Serial Number?
« on: March 04, 2022, 01:57:54 pm »
The PC serial # is the same as the chassis serial #. Located on the drivers side, look through the wind sheild from the outside in the lower corner. :)

Pages: [1] 2 3 ... 5