Hello Guest!

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - merkun

Pages: [1]
1
General Discussion / Re: Lifeline Battery Charging
« on: July 10, 2020, 06:23:57 pm »
Hi Ron, I will be adding 4 100 solar panels on the roof and will bring the charge line through the microwave oven vent into the kitchen area and mount the charge controller on the side entry panel below the kitchen extension and take the lines down to the batteries for charging.  If you have any questions please let me know.  I've done this in my former class A and it worked pretty well for boondocking and storage.

Mui

2
General Discussion / Re: Lifeline Battery Charging
« on: July 10, 2020, 03:36:13 pm »
Ron S and Ron D, thank for all your input.  I will be ordering the 4CT Lifeline batteries and installing Solar panels to charge them while boondocking and while the unit is in storage. 

3
General Discussion / Re: Lifeline Battery Charging
« on: July 08, 2020, 02:15:27 pm »
Thanks Ron.  Appreciate the input.

4
General Discussion / Re: Lifeline Battery Charging
« on: July 07, 2020, 08:49:33 pm »
Thank you FANDJ for your response.

5
General Discussion / Re: Lifeline Battery Charging
« on: July 07, 2020, 07:08:33 pm »
Ron and Don thank you for all your feedback, I will search for the 6CT photos.  My next project is solar panels hopefully will extend our boondocking experience.  When I had my Class A, I had installed Lifeline and solar panels and they worked out pretty well.

Mui

6
General Discussion / Re: Lifeline Battery Charging
« on: July 07, 2020, 01:13:20 pm »
Thanks Don, so is the Parrallax the charger?  Basically, do I need to make any adjustments to anything when I move over to AGM batteries from wet batteries?  Thanks

7
General Discussion / Lifeline Battery Charging
« on: July 07, 2020, 10:43:13 am »
Good Morning, I have a 2017 2552 Cruiser and planning on installing 2 Lifeline GPL 4CT 6Volt batteries.  I read the forum on installation but I did not see anybody talk about being able to change the Xantrex Pro XM 1800 inverter charging to AGM settings.  Currently, I have liquid batteries and all is set at the factory to Liquid Battery settings.  Some of you installed 6CT large size batteries which is my preference but not being able to see the way they positioned the 6CTs hard to visualize, if you have pictures I'll appreciate that also. 

Thanks for your input in advance.

Mui Erkun

Pages: [1]