Login

1

General Discussion / AC and heat

« on: September 11, 2021, 01:06:12 pm »

I have a 2020 2552 that I have only driven to storage, house, and to the dealers so everything is new to me.  Yesterday I turned both ACs on and left for about 35 minutes.  When I returned the furnace was blasting along with the two ACs.  What did I do wrong?  I have had several motorhomes over the years but this stumps me.

Does anyone have any idea of what I did so that I don't do this again?

Thanks for your help.

2

General Discussion / Re: Beeping driving me crazy

« on: October 26, 2020, 08:36:05 pm »

The beeping does not have the pattern you suggested.  More like the beeping you hear in the middle of the night when the battery needs to be replaced in a smoke detector.

Thanks

3

General Discussion / Beeping driving me crazy

« on: October 24, 2020, 05:33:07 pm »

I have a 2020 PC and there is this beeping similar to when a battery needs to be replaced in the smoke detector.  It is coming from the Convenience Center control panel behind the driver's seat.   Everything looks fine and nothing in the manual gives a hint as to where the beeping can be coming from.  I did notice the 'Bulk/Absorption' light blinking on the Samlex Solar panel but have no idea what that indicates either.

Also, a 'change oil' message is on even though it is a new unit.  Dealer said press the reset....did that but on the next start up I receive the 'change oil' message again

Any thoughts or suggestions?  My dealer responded with 'I dunno'

4

General Discussion / operating the back up cameras

« on: January 27, 2020, 07:40:54 pm »

I have a 2020 Cruiser and was told it has full time operational cameras...for the life of me I can't find a switch to turn on a full time camera and have found  nothing in the manual.  I know the backup and side camera comes on when put in reverse or when using the turn signal.  Can anyone help? 

Thanks