Login

1

General Discussion / Re: Water Intrusion when connected to city water at Camp site

« on: October 19, 2019, 07:57:21 pm »

Thanks for the info.. I removed the panel on the drivers side front of the bed. Mostly to dry out the carpet on the panel. The only thing I remember at that location looked like electrical or control wiring. Is there another panel in the rear I should try to access. Most of the ponding was near the drivers panel and some under the bed. I do not know the plumbing route for the unit it seemed strange to me that there is water routed to the from when kitchen & bath are all in the rear? 

Monday I pick up my unit for another trip & I am expecting rain .. So I will do some troubleshooting with the input I have been given .. does it leak during rain or just with city water.. locate values & fittings and tighten..

Appreciate your input will let you know how I make out.

Thanks
Robin

2

General Discussion / Water Intrusion when connected to city water at Camp site

« on: October 16, 2019, 08:23:52 am »

Good Morning

I have a 2018 Phoenix cruiser 2110 10k miles. Just started using it on some short trial runs. RV newbie except for childhood when my Dad was around. My problem is I hooked up to city water, turned the dial in the connection box to city. Cannot say the fitting was perfectly tight had some water seepage around the box. Slide out & Rain ... had water infiltration behind the drivers seat& under the bed. Once I disconnected the water I had no problem. I am curious what path the water could be taking to get to this spot form outside the motor home. Should I take it to service?

Robin