Login

1

General Discussion / Re: Replacement lever for adjusting seat back

« on: July 24, 2023, 10:00:47 pm »

That does look exactly like the front of my handle. Wish I could see the other side to see if the grooves look the same. I'll give them a call. Thanks so much.

2

General Discussion / Re: Replacement lever for adjusting seat back

« on: July 23, 2023, 03:08:20 pm »

Thanks so much for the info.
 I sent a tequest to the mothership parts department over a week and a half ago. Other than an auto-reply saying they would get back to me, I haven't heard a word.

3

General Discussion / Replacement lever for adjusting seat back

« on: July 16, 2023, 04:07:25 pm »

Anybody found a place to get a replacement lever to adjust the back of the driver's seat for a 2017 2552? I've tried Amazon, auto parts stores, Lowes, etc. already with no luck.

4

General Discussion / Re: Sanicon pump

« on: October 01, 2021, 11:26:34 pm »

Donc13--batteries connected, battery cutoff in correct position, valves worked....will look for 20 amp circuit breaker under hood tomorrow. Don't know how to get to the macerator itself.

2Lucky--- don't know where to get to the macerator itself.

5

General Discussion / Sanicon pump

« on: October 01, 2021, 04:49:13 pm »

This morning I dumped my black and gray tanks but the Sanicon pump would not come on. It worked fine when I used it last month. There was no noise or anything. I was able to empty and flush both tanks. Since there was no noise, I thought it might be a fuse. I looked where all the other fuses are but couldn't tell what it might be under. I think they must have had the employee with the worst possible writing label the fuses. Should I be looking somewhere else?

6

General Discussion / Re: Furnace and Heat strip

« on: October 01, 2021, 04:36:04 pm »

Thanks so much! I did the reinitializing the thermostat again. Didn't seem to make a difference but this morning I tried selecting the furnace and it worked! Next I selected the Heat Strip and it worked. Thanks so much.

7

General Discussion / Furnace and Heat strip

« on: September 30, 2021, 01:08:16 pm »

My last trip out this spring, the furnace fan would not quit running even when the furnace was not selected. Finally got it to stop by unhooking from shore power. Also, every time I turned the furnace on, the heat strip would come on. So the furnace then quit working and the Heat Strip came on on both the Heat Strip and Furnace settings.

I just now did the thermostat reset as posted by Donc13 back in December. Now neither the Heat Strip or the Furnace come on. Will be camping next three months so would like at least the furnace to work.

8

General Discussion / Re: Dead Radio, Backup Camera, Navigation

« on: July 22, 2020, 08:09:50 pm »

We checked all the fuses under the dash on the left as well as those in the engine compartment. They were all good.

9

General Discussion / Dead Radio, Backup Camera, Navigation

« on: July 22, 2020, 05:31:16 pm »

Need HELP. Picked up RV from storage this morning. Backup camera worked, radio was playing. Halfway home it quit. Husband and son checked every fuse they could find under dash and under hood. Checked for loose wires....nothing. Can anyone tell me what else to check?

10

General Discussion / Re: Generator Problem

« on: September 10, 2019, 09:12:29 pm »

Thanks for all the help. Thought I should let you know how it all worked out. I took the RV in to my RV guys this morning. Initially thought it was solenoid or relay but checked out the batteries first. They were both fine. Checked out the battery cutoff. It was fine. Tracked it to a problem with the ground. Under RV, the ground wire was just barely movable. Re-established the connection to the frame the a new bolt and those star connectors. Thirty minutes after arrival, all the DC power was working fine and generator started right up and I was on my way home. What a relief. Heading out Friday morning on a month long trip. Thanks again.

11

General Discussion / Re: Generator Problem

« on: September 05, 2019, 06:34:08 pm »

We were able to get the Genny running using the white rocker button on the dash while the engine was running. It ran great with a load and kept running fine after I turned the engine off. So, it looks like the Genny is not the problem.   I shut the Genny off and tried to restart as you normally would. It was a no go.....also no lights, pump, etc. The battery is still charged up just fine so I think there is a problem with the battery cut off switch or a relay or connection. I think this is going to be an RV tech fix.

12

General Discussion / Re: Generator Problem

« on: September 04, 2019, 06:51:03 pm »

The 13.4 was without the engine running. We are charging the battery now.

13

General Discussion / Re: Generator Problem

« on: September 04, 2019, 03:24:41 pm »

RV showed 13.4 on the Inverter when I got to storage. Drove RV home 10 miles so some additional charge. Light came on generator button when I tried to start. Didn't start and light went out. Tried to turn on water pump and light but got nothing. Seems like there is a disconnect between battery and power getting to anything in coach.

14

General Discussion / Re: Generator Problem

« on: September 02, 2019, 05:08:29 pm »

Thank you so much. I will head out to storage tomorrow and try your suggestions.

15

General Discussion / Re: Generator Problem

« on: September 02, 2019, 01:59:26 pm »

So I guess that means that the batteries could have just failed? I have a solar panel so do you think maybe the extra wires could be for it?  The RV is stored under a roof.   

As far as charging it as suggested above, the generator wouldn't start which is where this all started so I definitely won't be using it for charging. I guess I will need to bring it back to the house and put the batteries on a charger.

I may need two new batteries. If these either hold a charge or end up being replaced, could the battery problem be why the generator wouldn't start? The light on the switch didn't come on, there were no codes showing, and it didn't turn over.  My DH had me start the engine and try the generator. He said he heard it turn over once but didn't start and nothing lit up or showed codes.

One other question, are these the right kind of batteries for my set up?
Thanks for the help.