Login

1

General Discussion / Re: Front Seat Upholstery

« on: November 02, 2018, 06:16:15 pm »

Ron,
     If you want to install the rotate platform, I have on you can have.

Jim

2

General Discussion / Re: Rear wheel covers rotating

« on: August 19, 2018, 06:51:58 pm »

Bob, I make a 90 Degree bend about 6 to 8 inches from the point, then fish the tie rap through both holes, you might have to use a flash light to check between the 2 tires to make sure the tie rap is going through both holes then push it through the next to holes. I also have a pair of 12 inch surgical clamps to help along. Hope this will help you.

Jim

3

Adventure Anywhere / Re: Duluth rally then points west.

« on: August 19, 2018, 06:41:56 pm »

Kern & Bill have a great trip, Will see you there, Heading out Tue. 9/4 for Duluth Rally the heading South to do the Mississippi River Road trip.

Jim & Rae Anne

4

General Discussion / Re: V10 H.P. Reduction?

« on: July 20, 2018, 12:38:49 pm »

Joseph, Yes it will still go that high on a very steep hill or mountain. I run with the cruse control on all the time and if arounf a lot of stop and go I leave it out of tow mode. It will hold your speed very well. Did not look to see if you have a newer unit with the 6 speed trans, mine has the 5 speed trans. Hope this answer your question

Jim

5

General Discussion / Re: V10 H.P. Reduction?

« on: July 17, 2018, 10:06:52 pm »

Volkemon, Been using the five star since 2013, when I got my 3100, love it, didn't really see any increase of HP or Torque, but the transmission really works great, going up a rise in the road first goes to 2500 rpm then next it goes to 3200 rpm, if it a bad incline it goes to 3800 rpm. but most the time it will only drop to 2500 rpms. Hope you enjoy your new toy.

Jim

6

General Discussion / Re: Generator power

« on: July 09, 2018, 09:09:56 pm »

Had that happen to my unit a about 4 years ago. Turned out to be a bad fuel pump. You might want to check it out

Jim

7

General Discussion / Re: Chassis battery dead

« on: July 07, 2018, 08:22:15 pm »

hello, I have had the Chassis battery go dead just letting it set for a month, Now I put a float charger on the chassis battery when ever I leave it parked for more then 4 days with out starting, I did put in a relay system for my Ham Radio, so that when I plug into shore power it turns on my 13.8 power supply to the radios and also switches power to the chassis battery. When I disconnect from the shore power the relay go over the battery only. Ford has a lot of power being used just setting. This also happen on all my vehicles, so when I leave on a trip I put the float charger on the car at home. Hope this will help

Jim

8

General Discussion / Re: Where Do You Store Stuff?

« on: July 02, 2018, 11:20:49 am »

Mike and Cindy
        Starting at the Door of my 3100 and going toward back, Drawer next to batteries, Tools, Air Compressor, Lube, Yard Blanket, Warning Triangles. Big Drawer pullout I have 2 small tubs with spare water accessories, Connections, Fill Tube for fresh water, hose seals, the other box has elect supplies. above pullout drawer Big accessories, Surge Protector, Grill, Big bag of the tools, Ham Radio Equipment. On the back I put Chairs and table, Small fold up. On the Drivers side Drawer I put Electric Cords, Water Hoses, Water Filter, I over do the electric cords, Made up 20A, 30A & 50A plus a 25 ft 30A Extension Cord. 50Ft water Hose cut to different lengths. Hope this will help

Jim & Rae Anne

PS I also added a 6FT 5in square post under the unit for the black hose.

9

General Discussion / Re: Phoenix Cruiser Travel Club 2018 Rally

« on: June 21, 2018, 06:28:39 pm »

We are going to the Rally in Sept. I have a set of rear wheels inserts and a set of front wheel cover off my PC3100, Went with Aluminum wheels on the front and back, If someone want them let me know and I'll bring them to the Rally. Will need some elbow grease to clean them up. No Charge, FREE,

Jim & Rae Anne

10

General Discussion / Re: Forum Update May 22nd @ 8am EST

« on: May 25, 2018, 10:46:58 am »

I got the side bar to turn on by
1: Click on User Name 2: Click on Account Setting 3:On left side of page chick on Modify Profile 4: click on Look & Layout 5: move down the page to Use Side Bar and click on box 6: click all other option you want. 7:move down to bottom right on page and click on Change Profile. done
Hope this will help
Jim

11

General Discussion / Re: Has Anyone Upgraded the Rims and Tires on Their Phoenix Cruiser?

« on: May 17, 2018, 07:44:54 pm »

Ron,
     Only have taken on one trip, so have not seen any problem yet

Jim

12

General Discussion / Re: Has Anyone Upgraded the Rims and Tires on Their Phoenix Cruiser?

« on: May 16, 2018, 01:21:03 pm »

Ron,
     Here's the pictures of the front and rear wheels

Jim

13

Tips and Tricks / Re: Sewer Hose Storage

« on: May 13, 2018, 12:50:12 pm »

Here how I installed mine, hope I can get the pictures in

Jim

14

General Discussion / Re: Has Anyone Upgraded the Rims and Tires on Their Phoenix Cruiser?

« on: May 10, 2018, 11:36:07 am »

Ron, I got new tires and a PSI monitors system at the same time.

Jim

15

General Discussion / Re: Has Anyone Upgraded the Rims and Tires on Their Phoenix Cruiser?

« on: May 10, 2018, 10:45:55 am »

Ron, Got the Wheels at Peoria Plaza Tire in Peoria,
The wheels are 16x6 8x6.5 Pacer LT Mod @ $207.00 each
Will sent some pictures this next week when I pull the PC out of the Barn to get ready to head to Dayton for the Hamfest ( Amateur Radio Get together)
The new wheels make it easy to check and add air to the tires, on the rear inter wheel I just added a 4 inch straight extension, the front rear wheel air is on the flat part of the wheel pointing straight up.
Hope this will help, Could not find the ones I got on a search of the internet.

Jim