Cruisers Forum

Main Forum => General Discussion => Topic started by: CalCruiser on October 10, 2022, 07:31:21 pm

Title: Gen-Turi generator exhaust venting system?
Post by: CalCruiser on October 10, 2022, 07:31:21 pm

Has anyone here used a Camco Gen-Turi kit on a  PC with a slideout? The camping rules at Las Vegas Motor  Speedway require the generator exhaust to vent either at roof level or behind the rig into the street.

On my 2350  the Gen-Turi would have to run up along the angled transition wall panel between the driver side door and slideout. That would require either sticking 2 bungee cord anchors onto the transition panel, or possibly angling the vertical pipe slightly towards the back and attaching  the bungee cord anchors  to the forward facing slideout  wall.

Title: Re: Gen-Turi generator exhaust venting system?
Post by: mikeponiatowski on November 08, 2022, 03:04:48 pm

I have one for my 2007 PC 2100. It has the same setup as yours.  I have the Gen-Turi  run up along the angled transition wall panel between the driver side door and slideout.  I do have the sticking 2 bungee cord anchors on the transition panel.  No issues, small cord anchors not that big a deal.  Works just fine