Cruisers Forum

Main Forum => General Discussion => Topic started by: CABass on March 19, 2022, 07:24:16 pm

Title: 2350 Entry Door Hinge Pins
Post by: CABass on March 19, 2022, 07:24:16 pm

The entry door on my 2350 has started to sag a little and drags on the bottom of the doorframe when I open and close it. I can wiggle the door vertically by grasping it at the bottom, there is just a wee tiny little bit of slop in the door hinge pins.

If you have replaced your hinge pins, what did you use?

Title: Re: 2350 Entry Door Hinge Pins
Post by: CalCruiser on March 19, 2022, 09:40:55 pm

https://www.mcmaster.com/standard-washers/washers-4/washers-5/

Title: Re: 2350 Entry Door Hinge Pins
Post by: Tarnold on March 20, 2022, 09:22:57 am

Mine does the same.  I lifting the door and inserted a “C” clip under the hinge pin.   It helped for a while but it finally slipped out.  It is a quick and easy if you can get it to stay in.

Title: Re: 2350 Entry Door Hinge Pins
Post by: CABass on March 20, 2022, 03:34:48 pm

Quote from: Tarnold on March 20, 2022, 09:22:57 am

Mine does the same.  I lifting the door and inserted a “C” clip under the hinge pin.   It helped for a while but it finally slipped out.  It is a quick and easy if you can get it to stay in.

Good suggestion.  Thank you.

Title: Re: 2350 Entry Door Hinge Pins
Post by: CABass on March 20, 2022, 03:41:35 pm

Quote from: CalCruiser on March 19, 2022, 09:40:55 pm

https://www.mcmaster.com/standard-washers/washers-4/washers-5/

I don't think the pins are long enough to give enough room for a washer.