Cruisers Forum
Main Forum => General Discussion => Topic started by: Joe R on September 19, 2017, 07:43:42 am
-
Any body on this board traveling in Maine? I passed by one yesterday near Wilton, wasn't fast enough to see what state plate it had. Ours is in a services pro shop. The hot water tank wiring caught the white Styrofoam insulation on fire. And now the whole interior is covered with oily soot. Does any body know who makes the window blinds? They do not know if they can clean all the pleats on them. And may have to be scraped. We where lucky the whole rig did not go up in flames. Seeing it was parked right next to the house. When I got up one morning I heard the weirdest bird chirping. Well it turned out to be the smoke alarm after draining its battery. There is a scorch mark on the floor under the hot water tank. I am going to place a sheet of aluminum under the new tank just in case this happens again.
-
You can get the info at the plant... give them a call.Nothing will be instant unless you find it online. The parts lady has information if you can get a call back. Or just write your questions, short list so they get read. Send to Kermit. No one has time for long winded in this day and time. And they are usually helpful. If you dont find out I will go to the bus and get my packet of books and see what I can find for you.
Regards, Patricia
-
This must be he week for PC's in Maine. Saw another today on the same road. This one was pulling a toad with a couple of kayaks.
-
Just saw a FBP brown/tan yesterday in Arches NP visitor center lot with tow bar on the ground, obviously spending the day in the tow. It was surely longer than our 2350.
-
Some people who were at the rally were planning on returning east through Utah. Maybe one of them.