Cruisers Forum

Main Forum => Tips and Tricks => Topic started by: Sparky on May 23, 2013, 09:47:58 pm

Title: BATHROOM MAT AND RUG PROJECT
Post by: Sparky on May 23, 2013, 09:47:58 pm
I just completed my bathroom floor project. Added some gray foam mat and rug.  Please view at the following link

http://bathrooomproject.blogspot.com/

Sorry I keep doing my tips on this site, can not figure out how to load piks on this site

2008  PC 2350
Houston, Texas
David Sparks
Title: Re: BATHROOM MAT AND RUG PROJECT
Post by: aimee on May 24, 2013, 01:17:03 am
I don't mind that you do them and link to your own blog. It's not as if the entirety of your posting consists of external links. :)  Nice project!
Title: Re: BATHROOM MAT AND RUG PROJECT
Post by: Sparky on May 24, 2013, 10:09:55 am
tks Aimee,, when I clik on insert image I can not figure out how to put it in the message, will work on ii later,,, I think your right,,had about 1000 hits on my bicycle project so I guess people don't mind..I like doing project write ups to help people,,,, I have had so many people help me,, the RV communityas a whole is a wonderful community and go out of their way to help each other.
David
Title: Re: BATHROOM MAT AND RUG PROJECT
Post by: bgolden on May 24, 2013, 06:24:11 pm
Hi Sparky,  2o2

I just checked out your bathroom mats photos.  Nice Job. I may copy that idea.

You know, if you still have the pattern to that project you could find a few customers for it.

Bill G
Title: Re: BATHROOM MAT AND RUG PROJECT
Post by: Sparky on May 25, 2013, 10:04:46 am
Did not think about keeping the paper template,rats,,, i just put the beast in storage,,, write me an e-mail around the 15th of June and when i go out to run the gennie I will copy the grey mat for you, it was a pain doing all the measurements and then had to make some small adjustments.. BTW I should have mentioned when I marked the grey mat,, I went large, that way I could make small trims when i put it in the gray mat is easy to trim with a good razor
David
Title: Re: BATHROOM MAT AND RUG PROJECT
Post by: Ron Dittmer on May 26, 2013, 02:05:45 am
Nicely done! ;)